Plumber Mile End.
Loft conversions, designer kitchens, exposed copper that has to look the part.
Mile End plumbing is a different sport. Converted factories, exposed brick lofts, kitchens by architects, bathrooms with fixtures that cost more than your car. The work has to be code-compliant AND look the part — no sloppy joints behind drywall, no cheap valves on premium fixtures. Plomberie PSF does Mile End right. CMMTQ-licensed, RBQ-certified, 10+ years of working alongside designers and contractors on the high-end stuff. Clean copper runs, exposed-where-it-matters, hidden-where-it-should-be.
Loft conversions with original factory drainage
Old factories were not designed for residential bathrooms. We re-engineer the drain layout, properly vent the new fixtures, and make it pass inspection without compromising the open-concept aesthetic you bought the unit for.
Designer kitchen rough-in that has to be perfect
Pot filler over the range, instant hot at the prep sink, undersink filtration. We rough in clean, label the lines, and work to the millimetre so the cabinet guy and the counter guy never blame the plumber.
High-end fixtures with fussy install specs
European wall-mount toilets, thermostatic shower valves, freestanding tub fillers. We read the spec sheet, install per manufacturer, and the warranty stays valid. No guesswork, no "good enough".
Can you rough in plumbing for my Mile End loft conversion?
Yes — this is a big chunk of our Mile End work. We coordinate with your designer, electrician, and GC, lay out the drain and supply runs, and handle inspection sign-off. Plomberie PSF, CMMTQ-licensed, used to working in heritage industrial buildings.
I bought a $4k thermostatic shower valve. Can you install it?
We install it correctly, per the manufacturer spec, with the right rough-in depth and pressure-balanced supply. Most luxury fixture warranties require licensed install — we are it. Call (514) 665-6560 and we will quote on spec.
Do you work with interior designers?
Often. We read drawings, attend site meetings if needed, and flag plumbing constraints early so the design adjusts before tile goes up. Designer-friendly, contractor-friendly, no ego.
Is exposed copper still doable in lofts?
Yes, and it can look stunning when done right. Clean solder joints, brushed or polished finish, properly supported. We have done full exposed runs in Mile End lofts that became part of the design feature.
Designer reno or loft conversion in Mile End? Plomberie PSF brings the licence, the patience, and the clean copper. Call (514) 665-6560 — your architect will be relieved.